Q:
Why doesn’t the table fit my machine?A: Our tables / inserts are designed to give you a flat sewing surface.When first putting our table on your machine, you start with the front left of the free arm.The table should be perfectly level with your free arm where your fabric is going to go from our table onto your free arm right where your needle is at.If this is not level, even a 1/16 inch off, it will not fit your machine correctly.
Secondly, your machine may not be level.If you look closely you may see the machine is higher in the back than in the front.
Our table can only be level in one place, so if the machine is not level, our table will fit differently on one side than the other.
Our table is designed to fit over and around your machine in the back, once adjusted level in the front.
Unfortunately, when the machine is not level, we make the design that works the best and still allow the fabric to move freely and evenly from the front to the back without sewing uphill or falling off the back and pulling on your needle.
Q:
What is the best way to install the legs on my table?A: When installing legs place a soft cotton towel on a solid flat surface.Lay table upside down upon it.
Push the legs all of the way on.
Q:
Can I remove the legs from my table?A: Yes. To remove the legs, just wiggle (do not twist) them back and forth gently and pull them up and off.
You must support the acrylic. Never use a screw driver to remove the legs.
LINK GLIDER FOR FREE MOTION - RULER WORK AND GENERAL SEWING