Westalee Spinning Wheel These templates will create a variety of designs that can stand alone or be used to offset and echo a specific design.
Circles on Quilts Spinning Wheels create continuous circular patterns.
#36 - #27
*The individual Templates do not arrive with specific instructions for each Template looking at the two videos available gives us the general idea on how to use each Spinning Wheel Template Tips and Guidance for using any of the Spinning Wheel Templates
1) Place stable tape on the underside of your template at locations that would be pressure points when holding the template in place while sewing
2) Determine the desired placement of your template design within the block
3) Place the template at the beginning point of your desired design – make note of the markings on the template that you are using to create a consistent design
Step 1. Find the center of where you want to place your wreath.
Step 2. Insert the pin from under the quilt at the center, place the pin lock over the pin to hold the pin in place.
Step 3. Place the template over the pin and sew.
a.Make sure that your needle is in the middle of the foot to insure that you are sewing ¼ inch off the template edge
b. Place the ruler foot snugly against the template and pull your bobbin thread to the top
c. Begin sewing keeping the ruler foot touching the template, and tracing around the outside edge of the template
d. Once you are at the end of the template leave the needle down and move the template, line back up on the markings you selected and repeat this pattern until the end of the design, or the end of the block
looking at the two videos available gives us the general idea on how to use each Spinning Wheel Template
Spinning Wheels #36 is included in the Sampler Set