These two Templates are brought to a new life with Kate in this video!
Step 1. Find the center of where you want to place your wreath.
Step 2. Insert the pin from under the quilt at the center, place the pin lock over the pin to hold the pin in place.
Step 3. Place the template over the pin and sew.
a.Make sure that your needle is in the middle of the foot to insure that you are sewing ¼ inch off the template edge
b. Place the ruler foot snugly against the template and pull your bobbin thread to the top
c. Begin sewing keeping the ruler foot touching the template, and tracing around the outside edge of the template
d. Once you are at the end of the template leave the needle down and move the template, line back up on the markings you selected and repeat this pattern until the end of the design, or the end of the block
looking at the two videos available gives us the general idea on how to use each Spinning Wheel Template
